Phasechecker / Cabletester

This is the logical development of the Line Tester. A rectangle signal from the xlr device can feed the receiver module. The receiver module can provide the xlr device with phantom power and 2 implemeted led will indicate the phase of the received signal. An additional built-in microphone offers the possibility for the measurement of speaker system. This is probably the smallest phase - and cable tester combination on the market. Applications: The small xlr unit can be used as independent linetester without the receiver unit. The measurement functions of the Phantom Power Line Tester are implemented as well. Fixed installed multicores can be checked easily with both devices. The phase of a speaker systems can be checked easily with this combination. Specifications: Dimensions xlr device: 64mm Lenght x 19mm Diameter Connectors: 3 pin XLR, 1 GND, 2 +. 3 - Case construction : Neutric AC3F connector Signal output: ca. 6 pulses/sec. between pin 2 and 3 Amplitude: ca. 100 mV Power: 9 - 48 V Phantom power Dimensions receiver: 85 mm x 56 mm x 42 mm Case construction : Teko P1 ABS Gehäuse Connector: 3 pin XLR Female Power supply : 9V batterie, about 6mA current

Here is a photo of the transmitter unit: ...and here the photo from the transmitter and receiver   More Products...

Optogate GbR Selsinger Str. 28, 27404 Rhade, Germany    Ph: +49 4285 95156   Fax: +49 4285 95157    Em: info@optogate.com Copyright © 2005-6 All Rights Reserved